Cisco AIR-PCI340 Installation And Configuration Manual page 209

Chapter 10 Troubleshooting
Error Message Error Writing to Flash Memory
Explanation
Recommended Action
the firmware was flashed successfully. If the client adapter does not function or functions
improperly, your client adapter may need to be returned for service. Refer to the
Assistance Center"
Error Message Firmware Incompatible with Hardware
Explanation
Recommended Action
Error Message Firmware Upgrade Failed
Explanation
Recommended Action
the firmware was flashed successfully. If the client adapter does not function or functions
improperly, your client adapter may need to be returned for service. Refer to the
Assistance Center"
Error Message The installation will complete and applications will be installed when
a wireless LAN client adapter is inserted. If an adapter is already inserted,
remove and reinsert the adapter or reboot the machine.
Explanation
computer.
Recommended Action
program will then complete. If a client adapter was already inserted in your computer, eject and
reinsert the adapter or reboot your computer.
Error Message LEAP support has not been installed on this computer. You will not be
able to authenticate with this or any other profile configured to use LEAP.
Explanation
selected during installation. Therefore, the client adapter will not be able to authenticate using this
profile (or any other profile that is configured for LEAP).
Recommended Action
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-07
A problem occurred while the firmware was being flashed.
Eject the client adapter and reinsert it. If the client adapter functions properly,
section in the Preface for information on contacting TAC.
The selected firmware file does not work with the client adapter.
Select a different firmware file and try to load it.
A problem occurred while the firmware was being flashed.
Eject the client adapter and reinsert it. If the client adapter functions properly,
section in the Preface for information on contacting TAC.
The installation program was most likely run without a client adapter inserted in the
Insert a client adapter into your computer's client adapter slot. The installation
A LEAP profile was selected for use in ACM, but the LEAP security module was not
Run the installation program again and enable the LEAP security module.
Error Messages
"Technical
"Technical
10-15