Chapter 9
Routine Procedures
Client Adapter Software Procedures
This section provides instructions for the following procedures:
•
•
•
•
Upgrading the Client Adapter Software
Follow these steps to upgrade your Cisco Aironet CB21AG or PI21AG client adapter software to a more
recent release using the settings that were selected during the last installation.
Note
If you want to upgrade your client adapter software using new installation settings, uninstall the previous
installation (see the instructions on
page
Step 1
Make sure the client adapter is inserted in your computer.
Note
Use Windows Explorer to find the Install Wizard file.
Step 2
Double-click the file. The "Starting InstallShield Wizard" message appears followed by the Preparing
Step 3
Setup window (see
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
OL-4211-02
Upgrading the client adapter software,
Uninstalling the client adapter software,
ADU procedures,
page 9-7
ASTU procedures,
page 9-9
3-2).
If your client adapter is not inserted, the software cannot be upgraded.
Figure
9-1) and the Previous Installation Detected window (see
page 9-3
page 9-6
page
9-6); then install the new software (see the instructions on
Client Adapter Software Procedures
Figure
9-2).
9-3