General Error Messages - Cisco AIR-PCI340 Installation And Configuration Manual

Error Messages
Table 10-4 Locating Error Messages
Error Message Category
General
Installation
LEAP authentication
PEAP authentication
EAP-SIM authentication

General Error Messages

This section lists general error messages that may appear at any time and are not related to authentication
attempts.
Error Message Bad Firmware Image File (filename)
Error Message Card Removed at xx:xx
Error Message An error occurred while trying to make the selected profile active.
Error Message Error Reading filename
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
10-14
Explanation The selected firmware file is corrupt and will not be sent to the client adapter.
Select a different firmware file and try to load it.
Recommended Action
Explanation The client adapter was ejected from the computer.
Reinsert the client adapter if you wish to resume wireless communications.
Recommended Action
An error occurred when you selected a profile in ACM.
Explanation
Recommended Action Check the profile's configuration parameters in ACU or select a new profile.
Explanation A problem occurred while the computer was reading the firmware file from the disk.
Re-copy the firmware file to a floppy disk or to your computer's hard drive and
Recommended Action
try to load it again or select a different firmware file and try to load it.
Page Number
10-14
10-18
10-20
10-23
10-28
Chapter 10 Troubleshooting
OL-1394-07