Cisco AIR-PCI340 Installation And Configuration Manual page 108

Setting Network Security Parameters
Step 10 Check the Allow Fast Roaming (CCKM) check box on the Network Security screen if you want to
enable fast roaming for your client adapter.
• Checking this check box enables the client adapter to use CCKM when associated to an access point
that uses CCKM or to associate to access points that are not using CCKM.
• Unchecking this check box prevents the client adapter from using CCKM even with access points
that use it.
Default: Unchecked
Note
Step 11 Check the Allow Association to both WPA and non-WPA authenticators check box if you want to
allow the client adapter to associate to access points that are configured for LEAP authentication with:
• WPA enabled (associates with WPA security)
• WPA disabled or not supported (associates without WPA security)
Cisco migration mode, where WPA is optional (associates without WPA security)
•
If this check box is not checked, the client adapter can associate only to access points that are configured
for LEAP authentication with WPA.
Default: Unchecked
Note
Step 12 Click OK to exit the Network Security screen and return to the Profile Manager screen. On the Profile
Manager screen, click OK or Apply to save your changes.
Follow the steps below if the Microsoft 802.1X supplicant is installed on your computer and you want
Step 13
to take advantage of the fast roaming feature:
Perform one of the following steps, depending on your computer's operating system:
a.
–
–
–
b. Click the Authentication tab.
Note
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
5-38
Refer to the "Fast Roaming (CCKM)" section on page 5-26
This parameter is available only if you enable WPA.
If your computer is running Windows 98, 98 SE, NT, or Me, run the Microsoft 802.1X
Authentication Client application. Then go to
If your computer is running Windows 2000, double-click My Computer, Control Panel, and
Network and Dial-up Connections. Right-click Local Area Connection. Click Properties.
The Local Area Connection Properties screen appears.
If your computer is running Windows XP, double-click My Computer, Control Panel, and
Network Connections. Right-click Wireless Network Connection. Click Properties. The
Wireless Network Connection Properties screen appears. Select the Wireless Networks tab.
Uncheck the Use Windows to configure my wireless network settings check box unless you
are using Windows XP Service Pack 1.
In Windows Service Pack 1, the Authentication tab has moved from its previous location. To
access it, make sure the Use Windows to configure my wireless network settings check
box is checked. Select the SSID of the profile you are creating from the list of available
networks and click Configure. If your profile's SSID is not listed, click Add, enter your
profile's SSID in the Network name (SSID) field, and select the Authentication tab.
Chapter 5 Configuring the Client Adapter
for additional information.
Step c.
OL-1394-07