Cisco AIR-PCI340 Installation And Configuration Manual page 158

Viewing Statistics for Your Client Adapter
Table 7-4
Statistic
Partial Packets Received
SSID Mismatches
AP Mismatches
Data Rate Mismatches
WPA Mismatches
Authentication Rejects
Authentication Time-out
Association Rejects
Association Time-out
Packets Aged
Packets MIC OK
Packets No MIC
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
7-14
Client Adapter Statistics (continued)
Description
The number of fragments that were discarded because the entire
packet was not received successfully.
The number of times the client adapter tried to associate to an
access point but was unable to because the adapter's SSID was not
the same as the access point's.
The number of times the client adapter tried to associate to an
access point but was unable to because the access point was not
the adapter's specified access point.
Note
The number of times the client adapter tried to associate to an
access point but was unable to because the adapter's data rate was
not supported by the access point.
Note
The number of probe responses or beacons received that do not
qualify for association because of a mismatched WPA
information element. WPA information elements are sent by
access points to advertise supported authentication modes and
supported ciphers.
Note
The number of times the client adapter tried to authenticate to an
access point but was rejected.
The number of times the client adapter tried to authenticate to an
access point but was unable to because the access point did not
respond fast enough (timed out).
The number of times the client adapter tried to associate to an
access point but was rejected.
The number of times the client adapter tried to associate to an
access point but was unable to because the access point did not
respond fast enough (timed out).
The number of packets received successfully but discarded by the
client adapter because either all fragments were not received
within 10 seconds or the host did not read the packet from the
adapter within 10 seconds.
The number of packets that were received successfully with a
valid message integrity check (MIC).
Note
The number of packets that were discarded because no MIC was
found.
Note
Refer to the Specified Access Point 1- 4 parameter in
Table 5-4 for information on specifying access points.
Refer to the Data Rate parameter in
information on supported data rates.
This field is displayed only if WPA is enabled.
This field is displayed only if MIC is enabled on the
access point.
This field is displayed only if MIC is enabled on the
access point.
Chapter 7 Performing Diagnostics
Table 5-3 for
OL-1394-07