Ramp Warning; Tx Matrix Plus Laser And Led Guidelines And Warnings; Tx Matrix Plus Laser And Led Safety Guidelines; General Laser Safety Guidelines - Juniper TX MATRIX PLUS Hardware Manual

TX Matrix Plus Router Hardware Guide
Related
Documentation

TX Matrix Plus Laser and LED Guidelines and Warnings

TX Matrix Plus Laser and LED Safety Guidelines

404

Ramp Warning

WARNING: When installing the router, do not use a ramp inclined at more
than 10 degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10
graden.
Varoitus Älä käytä sellaista kaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10
degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
Avvertenza Non usare una rampa con pendenza superiore a 10 gradi.
Advarsel Bruk aldri en rampe som heller mer enn 10 grader.
Aviso Não utilize uma rampa com uma inclinação superior a 10 graus.
¡Atención! No usar una rampa inclinada más de 10 grados
Varning! Använd inte ramp med en lutning på mer än 10 grader.
General Safety Guidelines for M Series, MX Series, and T Series Routers on page 391
Maintenance and Operational Safety Warnings for M Series, MX Series, and T Series
Routers on page 409
TX Matrix Plus Laser and LED Safety Guidelines on page 404
TX Matrix Plus Laser and LED Safety Warnings on page 405
General Laser Safety Guidelines on page 404
TX Matrix Plus Laser Safety Standards on page 405

General Laser Safety Guidelines

When working around components that contain lasers, observe the following safety
guidelines to prevent eye injury:
Do not look into unterminated ports or at fibers that connect to unknown sources.
Do not examine unterminated optical ports with optical instruments.
Avoid direct exposure to the beam.
Copyright © 2010, Juniper Networks, Inc.