Txp-Cip Alarm Relay Contacts - Juniper TX MATRIX PLUS Hardware Manual

TX Matrix Plus Router Hardware Guide
Related
Documentation
38
"Control Plane Connections from the TX Matrix Plus Router to the T1600 Routers" on
page 58.
NOTE: The ports labeled
use.
Reserved Ports
Each TXP-CIP contains two copper RJ-45 ports, labeled
future use.
SFC Control Plane Ports
Each TXP-CIP contains five 10-Gigabit Ethernet SFP+ ports labeled
through .
XGE0 XGE4
NOTE: These ports are reserved for future use.

TXP-CIP Alarm Relay Contacts

Each TXP-CIP has two alarm relay contacts—labeled
(see Figure 19 on page 37), located on the bottom of the TXP-CIP. You can connect the
TX Matrix Plus router to external alarm-reporting devices by attaching wires to the alarm
relay contacts.
NOTE: If your TX Matrix Plus router contains two host subsystems, we
recommend that you connect each relay contact on each TXP-CIP to a
separate reporting device.
The terminal blocks that plug into the alarm relay contacts are supplied with the TX
Matrix Plus router. They accept wire of any gauge between 28-AWG and 14-AWG (0.08
2
and 2.08 mm ), which is not provided. Use the wire gauge appropriate for the external
device you are connecting.
Whenever a system condition triggers either the red or yellow alarm on the craft interface,
the corresponding alarm relay contacts are also activated. The alarms on
TXP-CIP-1 correspond to the Routing Engines installed into the TXP-CBs in slots
and .
CB1
TX Matrix Plus TXP-CIP LEDs on page 39
Troubleshooting the TX Matrix Plus TXP-CIPs on page 309
Replacing a TX Matrix Plus TXP-CIP on page 327
TX Matrix Plus Alarm Relay Contact Wire Specifications on page 444
4 through 15 on a TXP-CIP are reserved for future
and
16
RED ALARM
Copyright © 2010, Juniper Networks, Inc.
,that are reserved for
17
SFC CTRL PLANE
and
YELLOW ALARM
and
TXP-CIP-0
CB0