Juniper TX MATRIX PLUS Hardware Manual page 322

TX Matrix Plus Router Hardware Guide
288
84
SIB F2S 22
84
SIB F2S 23
84
SIB F2S 24
84
SIB F2S 25
84
SIB F2S 26
84
SIB F2S 27
84
SIB F2S 28
84
SIB F2S 29
84
SIB F2S 30
84
SIB F2S 31
84
SIB F2S 32
84
SIB F2S 33
84
SIB F2S 34
84
SIB F2S 35
84
Issue the show chassis alarms sfc 0
7.
an alarm condition:
user@host> show chassis alarms sfc 0
Temperature hot:
LED on one or both of the power supplies is not lit—Verify that the power
PEM OK
supply fans are operating.
LED on one or both of the power supplies is lit—Verify that the power
FAULT
supply fans are operating.
If both power supplies fail, the system temperature might have exceeded the
threshold, causing the system to shut down. If the TX Matrix Plus router
temperature exceeds the acceptable maximum, the TXP-CB turns off the power
supplies.
Fan Failure—If the other fans are functioning normally, a fan is probably faulty and
you need to replace the fan tray.
For information about the alarms, see Table 49 on page 289.
The text in the column labeled "LCD Message" appears in the display of the craft interface.
The text in the column labeled "CLI Message" appears in the output from the
show chassis alarms command.
64 70 76
64 70 76
64 70 76
64 70 76
64 70 76
64 70 76
64 70 76
64 70 76
64 70 76
64 70 76
64 70 76
64 70 76
64 70 76
64 70 76
command to get information about the source of
Copyright © 2010, Juniper Networks, Inc.
72 90
72 90
72 90
72 90
72 90
72 90
72 90
72 90
72 90
72 90
72 90
72 90
72 90
72 90