Reinstalling The Host Subsystems - Juniper TX MATRIX PLUS Hardware Manual

Reinstalling the Host Subsystems

Copyright © 2010, Juniper Networks, Inc.
To reinstall the host subsystems—TXP-CBs and Routing Engines (see Figure 66 on
page 150):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point.
Carefully align the bottom and then the top edges of the host subsystem with the
2.
guides inside the chassis.
Slide the host subsystem into the chassis, carefully ensuring that it is correctly aligned.
3.
Grasp both ejector handles and press them inward to seat the host subsystem until
4.
the ejectors latch into the faceplate.
Repeat the procedure to reinstall the remaining host subsystem.
5.
Chapter 11: Installing the TX Matrix Plus Router Using a Mechanical Lift
149