Monitoring Bfd; System Event Logs - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP SERVICES CONFIGURATION GUIDE 2010-10-01 Configuration Manual

JunosE 11.3.x IP Services Configuration Guide
clear ipv6 bfd session

Monitoring BFD

System Event Logs

114
host1#clear bfd session
Example 2
host1#clear bfd session address 10.10.5.24
Example 3
host1#clear bfd session discriminator 4
There is no no version.
See clear bfd session.
NOTE: When the clear bfd session command is executed, the BFD sessions
move to the Admin Down state before restarting the BFD sessions so that
the client applications are not impacted.
Use to restart all IPv6 BFD sessions or a specified IPv6 BFD session.
Use the address keyword to indicate the IPv6 address of the destination to which the
session has been established.
Example 1
host1#clear ipv6 bfd session
Example 2
host1#clear ipv6 bfd session address 1::4
There is no no version.
See clear ipv6 bfd session.
This section lists the system event logs associated with the BFD protocol and describes
the show commands you can use to view BFD-related information.
To troubleshoot and monitor BFD, use the following system event logs:
bfdGeneral
bfdSession
bfdEvents
bgpConnections
isisBfdEvents
ospfEvents
Copyright © 2010, Juniper Networks, Inc.