Clearing Bfd Sessions - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP SERVICES CONFIGURATION GUIDE 2010-10-01 Configuration Manual

bfd adapt
clear bfd adapted-intervals

Clearing BFD Sessions

clear bfd session
Copyright © 2010, Juniper Networks, Inc.
NOTE: Enabling BFD adaptive timers targets only rapidly flapping events
and not genuine BFD down events. If BFD down events occur in intervals
longer than 5 seconds, the session does not attempt to adapt.
Disabling BFD adaptive timers does not affect current adaptive timer intervals for sessions.
Disabling adaptive timers prohibits BFD from further adapting timer intervals for existing
sessions or for new sessions.
To reset adapted intervals for all BFD sessions on the router, use the clear bfd
adapted-intervals command.
Use to enable all BFD sessions to adapt timer intervals on all virtual routers on the
router.
Example
host1(config)#bfd adapt
Use the no version to disable subsequent BFD sessions from adapting timer intervals
without resetting any already adapted intervals.
See bfd adapt.
Use to reset adapted timer intervals for all BFD sessions on the router.
Does not disable the state of the BFD adaptive timer interval feature.
Example
host1#clear bfd adapted-intervals
There is no no version.
See clear bfd adapted-intervals.
You can use the clear bfd session or clear ipv6 bfd session commands to clear one or
more BFD sessions for IPv4 or IPv6 (respectively).
Use to restart all IPv4 BFD sessions or a specified IPv4 BFD session.
Use the address keyword to indicate the IPv4 address of the destination to which the
session has been established.
Use the discriminator keyword to clear the BFD session associated with the unique
system-wide identifier.
Example 1
Chapter 4: Configuring BFD
113