Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP SERVICES CONFIGURATION GUIDE 2010-10-01 Configuration Manual page 78

JunosE 11.3.x IP Services Configuration Guide
show ip redistribute
52
For field descriptions, see the show commands for the individual routing protocols in
their respective Configuration Guide chapters.
Example
host1#show ip protocols
Routing Protocol is
Default local preference is 100
IGP synchronization is enabled
Always compare MED is disabled
Router flap damping is disabled
Administrative Distance: external 20 internal 200 local 200
Neighbor(s):
No neighbors are configured
Routing for Networks:
Routing Protocol is
Distance is 110
Address Summarization:
None
Routing for Networks:
Routing Protocol is
Router Administrative State: enable
System version RIP1: send = 1, receive = 1 or 2
Update interval: 30 seconds
Invalid after: 180
hold down time: 120 seconds
flushed interval: 300 seconds
Filter applied to outgoing route update is not set
Filter applied to incoming route update is not set
No global route map
Distance is 120
Interface
Routing for Networks:
10.2.1.0/255.255.255.0
See show ip protocols.
Use to display configured route redistribution policy.
Field descriptions
To—Protocol into which routes are distributed
From—Protocol from which routes are distributed
status—Redistribution status
route map number—Number of the route map
Example
bgp 1"
ospf 255" with Router ID 100.100.100.1
rip"
seconds
Tx Rx Auth
Copyright © 2010, Juniper Networks, Inc.