Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP SERVICES CONFIGURATION GUIDE 2010-10-01 Configuration Manual page 274

JunosE 11.3.x IP Services Configuration Guide
248
Tunnel up/down trap—Indicates whether or not the E Series router sends traps to
SNMP when the operational state of the tunnels changes, enabled or disabled
Tunnel server location—Location of the tunnel server in slot/port format (ERX7xx
models, ERX14xx models, and the ERX310 router) or slot/adapter/port format (E120
and E320 routers).
Tunnel is secured by ipsec transport interface—IPSec interface that secures the
tunnel.
Tunnel administrative state—Configured state of the tunnel: up or down
Statistics—Details of packets received or transmitted by the tunnel
Packets—Number of packets received or transmitted by the tunnel
Octets—Number of octets received or transmitted by the tunnel
Discards—Number of packets not accepted by the tunnel
Errors—Number of packets with errors received or transmitted by the tunnel
Data rx—Received data
Data tx—Transmitted data
Number of tunnels found—Total number of GRE tunnels found
Number of static tunnels—Number of tunnels created statically
Example 1
host1#show gre tunnel
3 GRE tunnels found
3 tunnels were created static
Example 2
host1#show gre tunnel detail
Tunnel operational configuration
Tunnel name is 'vr1
Tunnel mtu is '10240'
Tunnel source address is '10.0.0.2'
Tunnel destination address is '10.0.0.1'
Tunnel transport virtual router is vr1
Tunnel mdt is disabled
Tunnel checksum option is disabled
Tunnel up/down trap is enabled
Tunnel server location is 4/0
Tunnel administrative state is up
Statistics packets
Data rx 0
Data tx 0
Tunnel operational configuration
Tunnel name is 'default'
Tunnel mtu is '10240'
Tunnel source address is '10.0.0.1'
octets discards
0 0
0 0
Copyright © 2010, Juniper Networks, Inc.
errors
0
0