Clearing Access List Counters; Creating Table Maps; Table 3: Match And Set Policy Values - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP SERVICES CONFIGURATION GUIDE 2010-10-01 Configuration Manual

JunosE 11.3.x IP Services Configuration Guide

Clearing Access List Counters

clear access-list
clear ipv6 access-list

Creating Table Maps

30
host1(config-if)#ip address 102.0.0.1 255.255.255.255
host1(config-if)#ip pim sparse-mode
host1(config-if)#ip pim join-filter silver
Enable PIM sparse mode on another subinterface and assign the gold join filter.
7.
host1(config-if)#interface atm 3/0.103
host1(config-if)#ip address 103.0.0.1 255.255.255.255
host1(config-if)#ip pim sparse-mode
host1(config-if)#ip pim join-filter gold
For information about the ip pim join-filter command, see Configuring PIM for IPv4
Multicast in JunosE Multicast Routing Configuration Guide. For information about the ipv6
pim join-filter command, see Configuring PIM for IPv6 Multicast in JunosE Multicast Routing
Configuration Guide.
Use the clear access-list or clear ipv6 access-list commands to clear access list counters.
Use to clear all access list counters or access list counters in the specified access list.
Example 1
host1#clear access-list list1
Example 2
host1#clear ipv6 access-list list2
There is no no version.
See clear access-list.
See clear ipv6 access-list.
For static routes and access routes, you can configure and apply a table map that filters
routes before an access list adds them to the routing table. For static routes, you can use
the ip static-route table-map or ipv6 static-route table-map command. For access
routes, you can use the ip access-route table-map or ipv6 access-route table-map
command.
Use these commands when triggering on the policy values listed in Table 3 on page 30.

Table 3: Match and Set Policy Values

Match Set
ip address metric
metric distance
Copyright © 2010, Juniper Networks, Inc.