Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP SERVICES CONFIGURATION GUIDE 2010-10-01 Configuration Manual page 276

JunosE 11.3.x IP Services Configuration Guide
show gre tunnel summary
250
Data rx 0
Data tx 0
GRE tunnel end is Up
Tunnel operational configuration
Tunnel mtu is '10240'
Tunnel source address is '15.0.0.2'
Tunnel destination address is '15.0.0.1'
Tunnel transport virtual router is vpnA
Tunnel checksum option is disabled
Tunnel sequence number option is disabled
Tunnel up/down trap is enabled
Tunnel-server location is 1/0/0
Tunnel administrative state is Up
Statistics packets
Data rx 0
Data tx 0
2 GRE tunnels found
2 tunnels were created static
See show gre tunnel.
Use to display a summary of information about GRE tunnels.
Field descriptions
Administrative status
enabled—Tunnel is available for use
disabled—Tunnel is not available for use
Operational status
up—Tunnel is operational
down—Tunnel is not operational
not-present—Tunnel is not operational, because the hardware (such as a line
module) supporting the tunnel is inaccessible
Example
host1#show gre tunnel summary
Administrative status
Operational status
See show gre tunnel.
0
0
octets
0
0
enabled disabled
3 0
up down not-present
3 0 0
Copyright © 2010, Juniper Networks, Inc.
0 0
0 0
discards errors
0 0
0 0