Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP SERVICES CONFIGURATION GUIDE 2010-10-01 Configuration Manual page 290

JunosE 11.3.x IP Services Configuration Guide
264
tunnel mtu—Value of the tunnel MTU
ipsec transport mode—Status of IPSec transport mode configuration; enabled or
disabled
tunnel mdt—Status of IPSec transport mode configuration; enabled or disabled
profile—Name of the profile assigned for upper IP interfaces
virtual router—Name of the transport virtual router assigned to the destination profile
tunnel destination subnet—Value of the configured destination address subnet
tunnel source—Value of the configured source address
Example 1—Displays all GRE destination profiles configured on the system
host1#show gre destination profile
default gre destination profile global
gre destination profile boston1
gre destination profile boston2
3 gre destination profiles found
the default destination profile is present
Example 2—Displays a specific GRE destination profile used for dynamic IP tunnel
creation
host1#show gre destination profile boston1
gre destination profile boston1
tunnel checksum disabled
tunnel sequence-datagrams disabled
tunnel mtu 10240
ipsec transport mode disabled
tunnel mdt disabled
profile kanata
virtual router vr1
tunnel destination subnet 10.0.0.0 255.0.0.0
tunnel source 1.1.1.1
tunnel source 1.1.1.2
tunnel source 1.1.1.3
Example 3—Displays a specific GRE destination profile used in a MVPN
host1#show gre destination profile boston2
gre destination profile boston2
tunnel checksum disabled
tunnel sequence-datagrams disabled
tunnel mtu 10240
ipsec transport mode disabled
tunnel mdt profile kanata-mdt
profile kanata
virtual router vr2
tunnel destination subnet 224.0.0.0 255.0.0.0
tunnel source 1.1.1.1
tunnel source 1.1.1.2
tunnel source 1.1.1.3
See show gre destination profile.
Copyright © 2010, Juniper Networks, Inc.