Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP SERVICES CONFIGURATION GUIDE 2010-10-01 Configuration Manual page 209

show subscribers
Copyright © 2010, Juniper Networks, Inc.
Peer IPsec identity: invalid identity
Lifetime: between 1800 and 7200 seconds, and between 100000 and 500000
KB
Reachable networks: none
PFS not configured
Transforms:, tunnel-esp-3des-sha1
Subscribers rejected due to maximum subscribers limit: 0
Completed sessions: 43, totaling 4873 seconds, statistics:
ipsec stats:
outbound:
outboundUserPacketsReceived = 88
outboundUserOctetsReceived
outboundAccPacketsReceived = 88
outboundAccOctetsReceived = 79168
outboundOtherTxErrors = 0
outboundPolicyErrors = 0
inbound:
inboundUserPacketsReceived = 88
inboundUserOctetsReceived
inboundAccPacketsReceived
inboundAccOctetsReceived
inboundAuthenticationErrors= 0
inboundReplayErrors = 0
inboundPolicyErrors = 0
inboundOtherRxErrors = 0
inboundDecryptErrors = 0
inboundPadErrors = 0
See show ipsec tunnel profile.
Use to display the active subscribers on the router.
Field descriptions
User Name—Name of the subscriber
Type—Type of subscriber: atm, ip, ipsec, ppp, tnl (tunnel), tst (test)
Addr | Endpt—IP or IPv6 address and source of the address: l2tp, local, dhcp, radius,
user. For local, dhcp, radius, and user endpoints, the address is that of the user. When
the endpoint is l2tp, the address is that of the LNS.
Virtual Router—Name of the virtual router context
Interface—Interface specifier over which the subscriber is connected
Login Time—Date, in YY/MM/DD format, and time the subscriber logged in
Circuit Id—User's circuit ID value specified by PPPoE
Remote Id—User's remote ID value specified by PPPoE
Example
host1#show subscribers
Chapter 6: Configuring Dynamic IPSec Subscribers
= 74544
= 74880
= 88
= 79488
Subscriber List
----------------
Virtual
183