Monitoring NAT
Displaying the NAT License Key
show license nat
Displaying Translation Statistics
show ip nat statistics
Copyright © 2010, Juniper Networks, Inc.
This section explains how to view NAT license information, NAT statistics, NAT translation
entries, NAT address pool information, and NAT inside and outside rule settings.
The show license nat command displays the NAT license key.
Use to display the NAT license key configured on the router.
Example
host1#show license nat
Nat license is nat_license
See show license.
The show ip nat statistics command displays internal statistics that apply to NAT
operation.
Use to display internal NAT statistics.
Field descriptions
Last dynamic allocation failure—Completion level of any dynamic allocation failures;
the number of times the router attempted dynamic allocation but reached the
dynamic allocation entry limit
Current static translation entries
Inside Source Simple—Number of inside source simple static translations
Outside Source Simple—Number of outside source simple static translations
Inside Source Extended—Number of inside source extended static translations
Outside Source Extended—Number of outside source extended static translations
Dynamic Translation Type—Type of dynamic translation (inside source simple,
outside source simple, inside source extended )
Current—Current number of dynamic translations of the associated translation type
Peak—Peak number of dynamic translations of the associated translation type
Accumulated—Accumulated number of dynamic translations of the associated type;
this value reflects the accumulation of dynamic translations since the last router
reboot operation
Chapter 2: Configuring NAT
85
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP SERVICES CONFIGURATION GUIDE 2010-10-01 and is the answer not in the manual?