Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP SERVICES CONFIGURATION GUIDE 2010-10-01 Configuration Manual page 327

Copyright © 2010, Juniper Networks, Inc.
Interface profile is—Name of the host profile
Local host name is—Name of the local host
Ipsec transport is—Status of the IPSec transport connection: enabled or disabled
Disconnect-cause avp is—Status of the disconnect cause AVP generation: enabled
or disabled
Tunnels are single-shot—Indicates that single-shot tunnels are configured for this
host profile
Current session count is—Number of current sessions for the host profile
Example
host1#show l2tp destination profile westford
L2TP destination profile westford
Configuration
Destination address
Transport ipUdp
Virtual router default
Peer address 172.31.1.99
Statistics
Destination profile current session count is 1
Host profile attributes
Remote host is lac-1
Configuration
Tunnel password is password
Interface profile is tunneled-user
Local host name is lns-1
Ipsec transport is enabled
Disconnect-cause avp is enabled
Tunnels are single-shot
Statistics
Current session count is 1
1 L2TP host profile found
See show l2tp destination profile.
Chapter 12: Securing L2TP and IP Tunnels with IPSec
301