Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP SERVICES CONFIGURATION GUIDE 2010-10-01 Configuration Manual page 191

Copyright © 2010, Juniper Networks, Inc.
Tunnel pfs—PFS group in use on the tunnel: 0 (PFS is not in use), 1 (768-bit group),
2 (1024-bit group), 5 (1536-bit group)
Tunnel administrative state—Up, Down
Tunnel Operational Attributes—Displays statistics related to the tunnel lifetime
inbound/outboundSpi/SA—SPI in use on traffic received from or sent to the tunnel
inbound/outboundSa—SA in use on traffic received from or sent to the tunnel
inbound/outbound lifetime allowed—Negotiated time-based lifetime in seconds
inbound/outbound lifetime remaining—Number of seconds remaining before
time-based lifetime expires
inbound/outbound traffic allowed—Negotiated traffic-based lifetime in kilobytes
inbound/outbound traffic remaining—Number of additional kilobytes that tunnel
can send or receive before traffic-based lifetime expires
Tunnel Statistics—Displays statistics on traffic received on and sent from this tunnel
InUserPackets—Number of user packets received
InUserOctets—Number of octets received from user packets
InAccPackets—Number of encapsulated packets received
InAccOctets—Number of octets received in encapsulated packets
InAuthErrors—Number of authentication errors received
InReplayErrors—Number of replay errors in received traffic
InPolicyErrors—Number of policy errors in received traffic
InOtherRxErrors—Number of packets received that have errors other than those
listed above
InDecryptErrors—Number of decryption errors in received traffic
InPadErrors—Number of packets received that had invalid values after the packet
was decrypted
OutUserPackets—Number of user packets sent
OutUserOctets—Number of octets sent in user packets
OutAccPackets—Number of encapsulated packets sent
OutAccOctets—Number of octets sent in encapsulated packets
Chapter 5: Configuring IPSec
165