Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP SERVICES CONFIGURATION GUIDE 2010-10-01 Configuration Manual page 79

show ip route
Copyright © 2010, Juniper Networks, Inc.
host1#show ip redistribute
To ospf, From static is enabled with route map 4
To ospf, From connected is enabled with route map 3
See show ip redistribute.
Use to display the current state of the routing table, including routes that are not used
for forwarding.
You can display all routes, a specific route, all routes beginning with a specified address,
routes for a particular protocol (BGP, IS-IS, OSPF, or RIP), locally connected routes,
internal control routes, static routes, or summary counters for the routing table.
Field descriptions
Prefix—IP address prefix
Length—Prefix length
Type—Protocol type
Next Hop—IP address of the next hop
Dist—Distance metric for the route
Met—Number of hops
Intf—Interface type and interface specifier
Example 1
host1#show ip route
Protocol/Route type codes:
I1- ISIS level 1, I2- ISIS level2,
I- route type intra, IA- route type inter, E- route type external,
i- metric type internal, e- metric type external,
O- OSPF, E1- external type 1, E2- external type2,
N1- NSSA external type1, N2- NSSA external type2
Prefix/Length Type
------------- ----
172.16.2.0/24
10.10.0.112/32
10.1.1.0/24
Example 2
host1#show ip route static
Protocol/Route type codes:
I1- ISIS level 1, I2- ISIS level2,
I- route type intra, IA- route type inter, E- route type external,
i- metric type internal, e- metric type external,
O- OSPF, E1- external type 1, E2- external type2,
N1- NSSA external type1, N2- NSSA external type2
Prefix/Length
-------------
10.10.0.112/32
Next Hop Dist/Met
-------- --------
Bgp 192.168.1.102
Static 192.168.1.1
Connect 10.1.1.1
Type Next Hop Dist/Met
---- -------- --------
Static 192.168.1.1 1/1
Chapter 1: Configuring Routing Policy
Intf
------
20/1 fastEthernet0/0
1/1 fastEthernet0/0
0/1 atm3/0.100
Intf
------
fastEthernet0/0
53