Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP SERVICES CONFIGURATION GUIDE 2010-10-01 Configuration Manual page 288

JunosE 11.3.x IP Services Configuration Guide
262
discards—Number of packets not accepted by the tunnel
Errors—Number of packets with errors received or transmitted by the tunnel
Data rx—Received data
Data tx—Transmitted data
DVMRP tunnels found—Total number of DVMRP tunnels found
Tunnels were created dynamic—Number of tunnels created dynamically
Example 1—Displays three dynamic DVMRP tunnels
host1:vr11#show dvmrp tunnel
DVMRP tunnel mvpn-dynamic-1 is Up
DVMRP tunnel mvpn-dynamic-2 is Up
DVMRP tunnel mvpn-dynamic-3 is Down
3 DVMRP tunnels found
3 tunnels were created dynamic
Example 2—Displays the detail of a dynamically created DVMRP tunnel for the data
MDT application
host1:vr11#show dvmrp tunnel detail mvpn-dynamic-1
DVMRP tunnel mvpn-dynamic-1 is Up
tunnel is dynamic
Application is MVPN
Tunnel operational configuration
Tunnel mtu is '5000'
Tunnel source address is '1.1.1.1'
Tunnel destination address is '2.2.2.2'
Tunnel transport virtual router is vr1
Tunnel mdt is disabled
Tunnel up/down trap is enabled
Tunnel-server location is 4/0
Tunnel administrative state is Up
Statistics packets
Data rx 0
Data tx 0
1 DVMRP tunnel found
1 tunnel was created dynamically
Example 3—Displays the detail of a dynamically created DVMRP tunnel for the Mobile
IP application
host1:vr12#show dvmrp tunnel detail mobileIp-dynamic-1
DVMRP tunnel mobileIp-dynamic-1 is Up
tunnel is dynamic
Application is Mobile-IP
Tunnel operational configuration
Tunnel mtu is '5000'
Tunnel source address is '6.6.6.6'
Tunnel destination address is '3.3.3.3'
Tunnel transport virtual router is vr1
Tunnel mdt is disabled
Tunnel checksum option is disabled
octets discards
0 0
0 0
Copyright © 2010, Juniper Networks, Inc.
errors
0
0