Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP SERVICES CONFIGURATION GUIDE 2010-10-01 Configuration Manual page 143

Copyright © 2010, Juniper Networks, Inc.
Echo mode—State of echo mode (enabled or disabled; active or inactive)
Client—Name of the client
desired tx—Minimum transmit interval (in seconds) requested by the client
required rx—Minimum required receive interval (in seconds) specified by the client
multiplier—Multiplier requested by the client
TX FC-assisted?—Whether component in forwarding controller is acting to speed
transmission times, yes or no; forwarding controller assist available only for ES2
4G LM
Detection FC-assisted?—Whether component in forwarding controller is acting
to speed fast failure detection times, yes or no; forwarding controller assist available
only for ES2 4G LM
Example 1
host1#show bfd session
Address
-------------------------------------------------------------------------
172.16.1.2
172.16.1.1
172.16.1.3 AdminDown
Example 2—IPv4 version
host1#show bfd session detail
Address: 172.16.1.2
State UP on Interface FastEthernet1/4
Detection Time0.900, version v0
Local discriminator 3, Remote discriminator 1
Session up time 00:00:01:04, Up/Down count 1, Adapted 3 times
Local: min tx interval 0.3, min rx interval 0.3, multiplier 1
(Adapted) min tx interval 0.6, min rx interval 0, multiplier 3
Remote: min tx interval 0.3, min rx interval 0.3, multiplier 3
Local diagnostic: None, Remote diagnostic: None
Remote heard, hears us
Min async interval 0.3, min slow interval 0.3
Echo mode disabled/inactive
2 Clients:
Client OSPFv2, desired tx: 0.3, required rx: 0.3, multiplier 3
Client ISIS, desired tx: 0.3, required rx: 0.3, multiplier 3
TX FC-assisted? Yes, Detection FC-assisted? Yes
Example 3—IPv6 version
host1#show bfd session detail
Address fe80:1234::abcd
State UP on Interface FastEthernet1/3
Detection Time0.900, version v1
Local discriminator 3, Remote discriminator 1
Session up time 00:00:01:04, Up/Down count 1, Adaptivity disabled
Local: min tx interval 0.3, min rx interval 0.3, multiplier 3
(Adapted) min tx interval 0, min rx interval 0, multiplier 4
Remote: min tx interval 0.3, min rx interval 0.3, multiplier 3
Local diagnostic: None, Remote diagnostic: None
State Interface
Up FastEthernet1/4
Up FastEthernet1/5
FastEthernet1/2
Chapter 4: Configuring BFD
Detect Interval Mx
Time
0.900 0.300 3
0.900 0.300 3
0.900 0.300 3
117