Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP SERVICES CONFIGURATION GUIDE 2010-10-01 Configuration Manual page 286

JunosE 11.3.x IP Services Configuration Guide
show dvmrp tunnel
260
Use to display the configuration of DVMRP destination profiles.
Field descriptions
default dvmrp destination profile—Name of the modified default destination profile
on the system
dvmrp destination profile—Name of the DVMRP destination profiles configured on
the system
tunnel checksum—Status of tunnel checksum configuration; enabled or disabled
tunnel sequence-datagrams—Status of tunnel sequence datagrams configuration;
enabled or disabled
tunnel mtu—Value of the tunnel MTU
ipsec transport mode—Status of IPSec transport mode configuration; enabled or
disabled
tunnel mdt—Status of IPSec transport mode configuration; enabled or disabled
profile—Name of the profile assigned for upper IP interfaces
virtual router—Name of the transport virtual router assigned to the destination profile
tunnel destination subnet—Value of the configured destination address subnet
tunnel source—Value of the configured source address
Example 1—Displays all destination profiles configured on the system
host1#show dvmrp destination profile
default dvmrp destination profile global
dvmrp destination profile kanata1
dvmrp destination profile kanata2
3 dvmrp destination profiles found
the default destination profile is present
Example 2—Displays a specific destination profile
host1#show dvmrp destination profile kanata1
dvmrp destination profile kanata1
tunnel mtu 10240
ipsec transport mode disabled
tunnel mdt disabled
profile disabled
virtual router vr1
tunnel destination subnet 10.0.0.0 255.0.0.0
tunnel source 1.1.1.1
tunnel source 1.1.1.2
tunnel source 1.1.1.3
See show dvmrp destination profile.
Copyright © 2010, Juniper Networks, Inc.