Monitoring Bfd; System Event Logs - Juniper IP SERVICES - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x IP Services Configuration Guide
NOTE: When the clear bfd session command is executed, the BFD sessions move
to the Admin Down state before restarting the BFD sessions so that the client
applications are not impacted.
clear ipv6 bfd session

Monitoring BFD

This section lists the system event logs associated with the BFD protocol and describes
the show commands you can use to view BFD-related information.

System Event Logs

To troubleshoot and monitor BFD, use the following system event logs:
120
Monitoring BFD
Use the discriminator keyword to clear the BFD session associated with the
unique system-wide identifier.
Example 1
host1#clear bfd session
Example 2
host1#clear bfd session address 10.10.5.24
Example 3
host1#clear bfd session discriminator 4
There is no no version.
See clear bfd session.
Use to restart all IPv6 BFD sessions or a specified IPv6 BFD session.
Use the address keyword to indicate the IPv6 address of the destination to which
the session has been established.
Example 1
host1#clear ipv6 bfd session
Example 2
host1#clear ipv6 bfd session address 1::4
There is no no version.
See clear ipv6 bfd session.