Table of Contents
Advertisement
mdl carrier
mdl string
mdl transmit
Copyright © 2010, Juniper Networks, Inc.
Enable transmission of MDL messages.
4.
host1(config-controll)#mdl transmit path-id
host1(config-controll)#mdl transmit idle-signal
host1(config-controll)#mdl transmit test-signal
Use to specify that an interface is used in the carrier environment.
Example
host1(config-controll)#mdl carrier
Use the no version to restore the default situation, in which the interface does not
operate in the carrier environment.
See mdl carrier.
Use to specify an MDL message.
Example
host1(config-controll)#mdl string port 0800
Use the no version to restore the default value to the specified MDL message or to all
MDL messages.
See mdl string.
Use to enable transmission of MDL messages.
Specify the keyword path-id to transmit path identifications every second.
Specify the keyword idle-signal to send idle signals every second.
Specify the keyword test-signal to transmit test signals every second.
Example
host1(config-controll)#mdl transmit test-signal
Use the no version to disable transmission of the specified MDL message or all MDL
messages.
See mdl transmit.
Optional Tasks
The following configuration tasks are optional for T3 and E3 interfaces:
Specify the cable length (T3 only).
Change the clock source.
Change the framing format.
Chapter 2: Configuring T3 and E3 Interfaces
53
Advertisement
Table of Contents
