Table of Contents
Advertisement
JunosE 11.2.x Physical Layer Configuration Guide
Setting a Baseline
Output Filtering
baseline interface serial
baseline line interface sonet
baseline line path interface sonet
148
You can set statistics baselines for serial interfaces, subinterfaces, and circuits using the
baseline interface serial command. You can also set statistics baselines for the section,
line, and path layers using the baseline interface sonet command. Use the delta options
with the show commands to display statistics with the baseline subtracted.
You can use the output filtering feature of the show command to include or exclude lines
of output based on a text string you specify. See Command Line Interface in JunosE System
Basics Configuration Guide, for details.
Use to set a statistics baseline for serial interfaces.
The router implements the baseline by reading and storing the statistics at the time
the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
Use the delta keyword with the show interfaces serial command to view the baseline
statistics.
Example
host1#baseline interface serial 2/0:1/1
There is no no version.
See baseline interface.
Use to set a statistics baseline for the SONET/SDH line layer.
The router implements the baseline by reading and storing the MIB statistics at the
time the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
Use the total [ delta ] keywords with the show controllers sonet line command to
view the baseline statistics.
Example
host1#baseline line interface sonet 2/0
There is no no version.
See baseline line interface sonet.
Use to set a statistics baseline for the SONET/SDH path layer.
The router implements the baseline by reading and storing the MIB statistics at the
time the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
