Juniper JUNOSE 11.2.X PHYSICAL LAYER Configuration Manual page 178

JunosE 11.2.x Physical Layer Configuration Guide
156
Sync count—Number of times the pattern detector synchronized with the incoming
data pattern
Received bit count—Number of bits received
Error bit count—Number of bits with errors
Number of valid intervals—Number of 15-minute intervals since the line module was
last powered on or reset
Time elapse in current interval—Time (seconds) passed in current interval
Current Interval Counters—Statistics for the current 15-minute interval
P-bit errored seconds—Number of errored seconds encountered by a T3
P-bit severely errored seconds—Number of severely errored seconds encountered
by a T3
Severely errored frame seconds—Number of severely errored framing seconds
encountered by a T3
Unavailable seconds—Number of unavailable seconds encountered by a T3
Line code violations—Number of line code violations encountered by a T3
P-bit coding violations—Number of coding violations encountered by a T3
Line errored seconds—Number of line errored seconds encountered by a T3
C-bit coding violations—Number of C-bit coding violations encountered by a T3
C-bit errored seconds—Number of C-bit errored seconds encountered by a T3
C-bit severely errored seconds—Number of C-bit severely errored seconds
encountered by a T3
24 Hour Total counters—Statistics for last 24 hours
Example 1—This example shows all T3 controllers on the interface 2/1.
host1#show controllers sonet 2/1 ds3
Ds3 1
Description: ottawa211 ds3
Number of valid interval - 0
Time elapse in current interval - 696
Current Interval Counters
P-bit errored seconds
P-bit severely errored seconds = 0
Severely errored frame seconds = 0
Unavailable seconds
Line code violations
P-bit coding violations
Line errored seconds
C-bit coding violations
= 0
= 541
= 0
= 0
= 0
= 0
Copyright © 2010, Juniper Networks, Inc.