Configuring T3 Interfaces To Send Mdl Messages - Juniper JUNOSE 11.2.X PHYSICAL LAYER Configuration Manual

JunosE 11.2.x Physical Layer Configuration Guide
path ds3 shutdown
path ds3 snmp trap link-status
128
Example
host1(config-controll)#path 12 ds3 1 framing m23
Use the no version to restore the default value, c-bit parity framing.
See path ds3 framing.
Use to disable a T3 interface.
T3 interfaces are enabled by default.
Example
host1(config-controll)#path 12 ds3 1 shutdown
Use the no version to restart a disabled interface.
See path ds3 shutdown.
Use to enable SNMP link status processing for a T3 interface.
The default disables SNMP link status processing.
Example
host1(config-controll)#path 12 ds3 1 snmp trap link-status
Use the no version to disable SNMP link status processing.
See path ds3 snmp trap link-status.

Configuring T3 Interfaces to Send MDL Messages

You can configure a T3 interface to send MDL messages. MDL messages are supported
only when the T3 framing is set for C-bit parity, the default setting.
To configure a T3 interface to send MDL messages:
Specify a SONET interface.
1.
host1(config)#controller sonet 8/0
(Optional) Configure the interface to operate in an MDL carrier environment.
2.
host1(config-controll)#path 12 ds3 1 mdl carrier
Specify the MDL messages.
3.
host1(config-controll)#path 12 ds3 1 mdl string eic "ERX1410"
host1(config-controll)#path 12 ds3 1 mdl string fic "FG786"
host1(config-controll)#path 12 ds3 1 mdl string lic "Bldg 2"
host1(config-controll)#path 12 ds3 1 mdl string pfi "Site 1"
host1(config-controll)#path 12 ds3 1 mdl string port 0800
host1(config-controll)#path 12 ds3 1 mdl string unit 080001
Enable transmissions of MDL messages.
4.
host1(config-controll)#path 12 ds3 1 mdl transmit path-id
Copyright © 2010, Juniper Networks, Inc.