Table of Contents
Advertisement
description
framing
snmp trap ip link-status
Copyright © 2010, Juniper Networks, Inc.
Specify the keywords internal module to use the line module's internal clock as the
transmit clock.
Specify the keywords internal chassis to use the router's clock as the transmit clock.
Example
host1(config-controll)#clock source internal module
Use the no version to revert to the default, line.
See clock source.
Use to assign a text description or an alias to a channelized T3 interface.
You can use this command to help you identify the interface and keep track of interface
connections.
The description or alias can be a maximum of 80 characters.
Use "show controllers t3" on page 29 to display the text description.
Example
host1(config-controll)#description toronto ct3 interface
Use the no version to remove the text description or alias.
See description.
Use to configure the framing format for a T3 controller.
Specify either m23 or c-bit framing.
Choose the framing format that is compatible with the framing format of the Telco
network device at the other end of the line.
Select c-bit framing if you intend to configure MDL messages.
Example
host1(config-controll)#framing c-bit
Use the no version to restore the default value, c-bit.
See framing.
Use to enable SNMP link status processing on a T3 controller.
Example
host1(config-controll)#snmp trap link-status
Use the no version to disable SNMP link status processing.
See snmp trap ip link-status.
Chapter 1: Configuring Channelized T3 Interfaces
13
Advertisement
Table of Contents
