Juniper JUNOSE 11.2.X PHYSICAL LAYER Configuration Manual page 88

JunosE 11.2.x Physical Layer Configuration Guide
66
DSU mode—Mode of the fractional T3 lines: Digital Link mode or Larscom mode
DSU bandwidth—Speed of the fractional T3 lines
DSU scramble—Status of scrambling for fractional T3: on or off
MDL Transmit Path—Indicates whether the transmission is active or not active (T3
only)
MDL Transmit Test-Signal—Indicates if the transmission is active or not active (T3
only)
MDL Transmit Idle-Signal—Indicates if the transmission is active or not active (T3
only)
Equipment Identification Code—eic string for MDL (T3 only)
Line Identification Code—lic string for MDL (T3 only)
Frame Identification Code—fic string for MDL (T3 only)
Facility Identification Code—fic string for MDL (T3 only)
Equipment Port—port string for MDL (T3 only)
Unit Identification Code—unit string for MDL (T3 only)
Facility Identification Code—pfi string for MDL (T3 only)
Port Code—port string for MDL (T3 only)
Generator Number—generator string for MDL (T3 only)
BERT test—Number of current test and total number of tests (T3 only)
Test interval—Length of the BERT test
status—Sync (controller is synchronized with remote device) or NoSync (controller
is not synchronized with remote device)
Sync count—Number of times the pattern detector synchronized with the incoming
data pattern
Received bit count—Number of bits received
Error bit count—Number of bits with errors
Number of valid intervals—Number of 15-minute intervals since the T3 or E3 module
was last powered on or reset
Time elapse in current interval—Number of seconds that have passed in the 15-minute
(900 second) interval
Errored seconds—Number of errored seconds encountered by an E3 (not applicable
for T3) in the current interval (this field is not present for T3 controllers)
Copyright © 2010, Juniper Networks, Inc.