Juniper JUNOSE 11.2.X PHYSICAL LAYER Configuration Manual page 146

JunosE 11.2.x Physical Layer Configuration Guide
path ds1 fdl
path ds1 fdl carrier
path ds1 fdl string
124
(Optional) Configure the interface to operate in an FDL carrier environment.
3.
host1(config-controll)#path 2 ds1 1/1/1 fdl carrier
(Optional) Specify the FDL messages.
4.
host1(config-controll)#path 2 ds1 1/1/1 fdl string eic "ERX1410"
host1(config-controll)#path 2 ds1 1/1/1 fdl string lic "Bldg 10"
host1(config-controll)#path 2 ds1 1/1/1 fdl string fic "GY788"
host1(config-controll)#path 2 ds1 1/1/1 fdl string unit 080001
Enable transmission of FDL messages.
5.
host1(config-controll)#path 2 ds1 1/1/1 fdl transmit idle-signal
Use to specify the FDL standard for the interface.
Specify the keyword ansi to support the ANSI FDL standard (see "References" on
page 113).
Specify the keyword att to support the AT&T FDL standard (see "References" on
page 113).
Specify the keyword all to support both the ANSI and AT&T standards.
Specify the keyword none to remove the current FDL mode settings.
You can configure a different standard on each T1 channel.
Example
host1(config-controll)#path 2 ds1 1/1/1 fdl att
Use the no version to restore the default, none.
See path ds1 fdl.
Use to specify that an interface is used in the carrier environment.
Example
host1(config-controll)#path 2 ds1 1/1/1 fdl carrier
Use the no version to restore the default situation, in which the T1 interface does not
operate in the carrier environment.
See path ds1 fdl carrier.
Copyright © 2010, Juniper Networks, Inc.