Juniper JUNOSE 11.2.X PHYSICAL LAYER Configuration Manual page 40

JunosE 11.2.x Physical Layer Configuration Guide
t1 fdl carrier
t1 fdl string
t1 fdl transmit
18
Use the no version to restore the default, none.
See t1 fdl.
Use to specify that T1 channels are used in the carrier environment.
Example
host1(config-controll)#t1 6 fdl carrier
Use the no version to restore the default situation, in which the T1 channels do not
operate in the carrier environment.
See t1 fdl carrier.
Use to specify an FDL message as defined in the ANSI T1.403 specification.
NOTE: The router sends these FDL messages only if you have issued the t1 fdl command
with the ansi or all keyword and then issued the t1 fdl transmit command.
Example
host1(config-controll)#t1 6 fdl string eic "ERX1440"
Use the no version to restore the default value to the specified FDL message or to all
FDL messages.
See t1 fdl string.
Use to configure the router to send the specified type of FDL message.
By default, the router sends only FDL performance data messages.
NOTE: The router sends FDL messages specified with "t1 fdl string" on page 18 only if
you have issued the t1 fdl command with the ansi or all keyword. If you specified the
att keyword with the t1 fdl command, the router sends only performance data.
Specify the keyword path-id to transmit path identifications every second.
Specify the keyword idle-signal to send idle signals every second.
Specify the keyword test-signal to transmit test signals every second.
Example
host1(config-controll)#t1 28 fdl transmit path-id
Copyright © 2010, Juniper Networks, Inc.