Juniper JUNOSE 11.2.X PHYSICAL LAYER Configuration Manual page 38

JunosE 11.2.x Physical Layer Configuration Guide
t1 snmp trap link-status
t1 timeslots
16
Use to disable T1 channels or a subchannel.
To disable channels or a subchannel, specify one or more T1 channels or a subchannel
in channel or channel/subchannel format.
channel—One or more T1 channels, or a range of channels in the range 1–28
subchannel—Subchannel from 1–24
The T1 interface is enabled by default.
Example
host1(config-controll)#t1 4-15,18,21,25-27 shutdown
Use the no version to restart a disabled interface.
See t1 shutdown.
Use to enable SNMP link status processing on T1 channels.
To enable or disable SNMP on an interface, specify T1 channels or subchannel in channel
or channel/subchannel format.
channel—One or more T1 channels, or a range of channels in the range 1–28
subchannel—Subchannel from 1–24
Example
host1(config-controll)#t1 2 snmp trap link-status
Use the no version to disable SNMP link status processing.
See t1 snmp trap link-status.
Use to assign a range of DS0 timeslots to a subchannel as a single data stream.
To configure a subchannel, specify a T1 channel in channel/subchannel format and a
range of timeslots.
channel—T1 channel in the range 1–28
subchannel—Number from 1–24
dash—Represents a range of timeslots; a comma separates timeslots. For example,
1-10, 15-18 assigns timeslots 1–10 and 15–18.
Example
host1(config-controll)#t1 2/1 timeslots 1,3-8,10
You can specify a line speed that applies to all DS0 timeslots assigned to a subchannel.
The default line speed is 64 Kbps.
Use the no version to delete the fractional T1 circuit.
See t1 timeslots.
Copyright © 2010, Juniper Networks, Inc.