Monitoring Aps/Msp - Juniper JUNOSE 11.2.X PHYSICAL LAYER Configuration Manual

JunosE 11.2.x Physical Layer Configuration Guide

Monitoring APS/MSP

166
Ds0 mode—Nx56 or Nx64
5 minute input rate—Data rates based on the traffic received in the last five minutes
5 minute output rate—Data rates based on the traffic sent in the last five minutes
Interface Statistics
Packets received—Number of packets received on the interface
Bytes received—Number of bytes received on the interface
Errored packets received—Number of packets with errors received on the interface
Packets sent—Number of packets sent on the interface
Bytes sent—Number of bytes sent on the interface
Errored packets sent—Number of packets with errors sent from the interface
Example
host1#show interfaces serial 2/0:1/1/1/1/1
Serial Interface at 2/0:1/1/1/1/1
Description: toronto20 hdlc channel
ifOperStatus = ifOperUp
snmp trap link-status = disabled
Encapsulation hdlc
Crc type checking - CRC16
Hdlc mru = 1600
Hdlc mtu = 1600
Hdlc interface speed = 1536000
Hdlc idle-character marks
Invert data disabled, Ds0 time slot map = 0xffffff
Ds0 mode = Nx64
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Interface statistics
Packets received
Bytes received
Errored packets received
Packets sent
Bytes send
Errored packets sent
See show interfaces.
For information about monitoring APS/MSP, see "Monitoring APS/MSP" on page 102 in
"Configuring Unchannelized OCx/STMx Interfaces" on page 71.
100
1300
1
100
1436
0
Copyright © 2010, Juniper Networks, Inc.