Configuring T1 Channels To Send Fdl Messages - Juniper JUNOSE 11.2.X PHYSICAL LAYER Configuration Manual

JunosE 11.2.x Physical Layer Configuration Guide
path ds3 t1 timeslots
path ds3 t1 fdl
132
Use the no version to disable SNMP link status processing for a T1 channel.
See path ds3 snmp trap link-status.
Use to assign a range of DS0 timeslots to a subchannel as a single data stream.
You can specify a line speed for all DS0 timeslots assigned to a subchannel.
Examples
host1(config-controll)#path 2 ds3 1 t1 28 timeslots 1-10
host1(config-controll)#path 2 ds3 1 t1 28/1 timeslots 1-10 speed 56
Use the no version to delete the fractional T1 circuit.
See path ds3 t1 timeslots.

Configuring T1 Channels to Send FDL Messages

To configure T1 channels to send FDL messages:
Specify a SONET interface.
1.
host1(config)#controller sonet 8/0
Specify the standard for transmission of FDL messages on both ends of the T1
2.
connection.
host1(config-controll)#path 2 ds3 1 t1 28 fdl ansi
(Optional) Configure the interface to operate in an FDL carrier environment.
3.
host1(config-controll)#path 2 ds3 1 t1 28 fdl carrier
(ANSI signals) Specify the FDL messages.
4.
host1(config-controll)#path 2 ds3 1 t1 28 fdl string eic "ERX1410"
host1(config-controll)#path 2 ds3 1 t1 28 fdl string lic "Bldg 10"
host1(config-controll)#path 2 ds3 1 t1 28 fdl string fic "GY788"
host1(config-controll)#path 2 ds3 1 t1 28 fdl string unit 080001
Enable transmission of FDL messages.
5.
host1(config-controll)#path 2 ds3 1 t1 28 fdl transmit idle-signal
Use to specify the FDL standard for the interface.
Specify the T1 channels in the range 1 through 28.
Specify the keyword ansi to support the ANSI FDL standard (see "References" on
page 113).
Specify the keyword att to support the AT&T FDL standard (see "References" on
page 113).
Specify the keyword all to support both the ANSI and AT&T standards
Specify the keyword none to remove the current FDL mode settings
Copyright © 2010, Juniper Networks, Inc.