Juniper JUNOSE 11.2.X PHYSICAL LAYER Configuration Manual page 118

For e series broadband services routers - physical layer configuration

Table of Contents

JunosE 11.2.x Physical Layer Configuration Guide

Use to display the configuration for SONET and SDH interfaces.

Field descriptions

Interface specifier in slot/port format (ERX14xx models, ERX7xx models, and the

ERX310 router) or slot/adapter/port format (E120 and E320 routers)

non channelized—Unchannelized path

channelized—Number of channels and speed for the interface

ifAdminStatus—Configured status of the interface: up or down

description—Configured description of the controller

snmp trap link-status—State of SNMP link-status processing for the section and

line layers of the interface: enabled or disabled

alarms used for operational status calculation—Types of defects that the router

uses to determine the operational status of the interface at the section and line

layers

defect trigger soaking delay—Time that the router waits to set an alarm when the

router records a defect at the section or line layer

Operational Status—Physical state of the interface:

up—Interface is operational

down, failure alarm—Interface is not operational; type of defect that caused failure

is specified

time since last status change—Time since the module was rebooted

Loopback State—Type of loopback configured on the interface

Mode—Type of interface: SONET or SDH

Timing source—Type of clock source configured for the channel:

line—Internal clock is from the line module itself

chassis—Internal clock is from the configured router clock

Receive FIFO Overruns—Number of times received FIFO was overrun

Current section defects—Number of suspect bit patterns found in several consecutive

frames in section layer

Current line defects—Number of suspect bit patterns found in several consecutive

frames in line layer

Received SONET overhead—Section and line overhead bytes present in the receive

side of the interface at any particular time

Transmitted SONET overhead—Section and line overhead bytes present in the

transmit side of the interface at any particular time

Table of Contents

Junose 11.2.x