Juniper JUNOSE 11.2.X PHYSICAL LAYER Configuration Manual page 64

JunosE 11.2.x Physical Layer Configuration Guide
42
Fractional Interface—Location of a channelized T1 or E1 interface
Description—Text description or alias if configured for the interface
ifOperStatus—Administrative status of the interface
ifOperUp—Interface is functioning
ifOperTesting—Interface is being tested
ifOperNotPresent—Module has been removed from the chassis
ifOperDown—Interface is not functioning
ifOperLowerDown—Lower layer in the interface stack is not functioning
snmp trap link-status—Enabled or disabled
Encapsulation—Layer 2 encapsulation display; options include: ppp, frame-relay
ietf, mlppp, mlframe-relay ietf, hdlc
Crc type checking—Size of the CRC
Hdlc mru—Current size of the MRU
Hdlc mtu—Current size of the MTU
Hdlc interface speed—Current line speed of the interface
Hdlc idle-character—Current idle character
Invert data disabled—Status of the data inversion feature
Ds0 time slot map—Channelized T1 or E1 channel group
Ds0 mode—Nx56 or Nx64
5 minute input rate—Data rates based on the traffic received in the last five minutes
5 minute output rate—Data rates based on the traffic sent in the last five minutes
Interface statistics
Packets received—Number of packets received on the interface
Bytes received—Number of bytes received on the interface
Errored packets received—Number of packets with errors received on the interface
Packets sent—Number of packets sent on the interface
Bytes sent—Number of bytes sent on the interface
Errored packets sent—Number of packets with errors sent from the interface
Example
Copyright © 2010, Juniper Networks, Inc.