aps events
Copyright © 2010, Juniper Networks, Inc.
Use the no version to restore the default, 5 (for sd-ber) or 3 (for sf-ber), for the specified
alarm.
See threshold.
Configuration Example
The following example shows how to configure working and protect interfaces for
APS/MSP.
Configure the working interface.
1.
host1(config)#controller sonet 3/0
host1(config-controller)#aps group boston
host1(config-controller)#aps working 1
Configure the protect interface.
2.
host1(config-controller)#controller sonet 3/1
host1(config-controller)#aps group boston
host1(config-controller)#aps protect 0
host1(config-controller)#aps unidirectional
host1(config-controller)#aps revert 30
host1(config-controller)#threshold sf-ber 4
Configuring APS Event Collection
To configure line modules to deliver APS events to the necessary SNMP traps, issue the
aps events command from Global Configuration mode.
Use to enable line modules to deliver APS events to the necessary SNMP traps.
Use the list variable to deliver the following types of APS events:
all—Configure notification of all APS events
channel-mismatch—Configure notification of APS channel mismatches
feplf—Configure notification of APS far-end protection line failures
mode-mismatch—Configure notification of APS mode mismatches
psbf—Configure notification of APS protection signal byte failures
switchover—Configure notification of APS switchovers
Example
host1(config)#aps events channel-mismatch
Use the no version to disable the delivery of APS events from line modules to SNMP
traps.
See aps events.
Chapter 3: Configuring Unchannelized OCx/STMx Interfaces
91