Juniper JUNOSE 11.2.X PHYSICAL LAYER Configuration Manual page 91

show controllers t3 remote
Copyright © 2010, Juniper Networks, Inc.
5/10(channelized)
5/11(channelized)
3/0(channelized)
3/1(channelized)
3/2(channelized)
4/0:1/1(unchannelized)
4/2:1/1(channelized)
See show controllers e3.
See show controllers t3.
Use to display MIB statistics for the remote end of a T3 interface configured for MDL.
Specify the all option to display detailed information for all 15-minute intervals.
For definitions of the MIB statistics for a T3 interface, see RFC 2496—Definitions of
Managed Objects for the DS3/E3 Interface Types (January 1999).
Field descriptions
Far End MDL Carrier bit—Status of MDL configuration on remote device connected
to T3 interface
set—MDL is configured for carrier mode
not set—MDL is not configured for carrier mode
Far End Equipment Identification Code—eic string sent by remote device for MDL
Far End Line Identification Code—lic string sent by remote device for MDL
Far End Frame Identification Code—fic string sent by remote device for MDL
Far End Unit Identification Code—unit string sent by remote device for MDL
Far End Facility Identification Code—pfi string sent by remote device for MDL
Far End Generator Number—generator string sent by remote device for MDL
Far End Port Number—port string sent by remote device for MDL
Number of valid intervals—Number of 15-minute intervals since the line module was
last powered on or reset
Time elapse in current interval—Number of seconds that have passed in the 15-minute
(900-second) interval
C-bit errored seconds—Number of C-bit errored seconds encountered by a T3 in the
current interval
C-bit severely errored seconds—Number of C-bit severely errored seconds
encountered by a T3 in the current interval
C-bit coding violations—Number of C-bit coding violations encountered by a T3 in
the current interval
Chapter 2: Configuring T3 and E3 Interfaces
down down
down down
down down
down down
down down
up down
up lowerLayerDown
69