Juniper JUNOSE 11.2.X PHYSICAL LAYER Configuration Manual page 80

JunosE 11.2.x Physical Layer Configuration Guide
interface serial
invert data
load-interval
mru
58
Use to configure the HDLC idle character.
The idle character is sent between HDLC packets.
Specify one of the following idle characters:
flags—Sets the idle character to 0x7E
marks—Sets the idle character to 0xFF
Example
host1(config-if)#idle-character marks
Use the no version to restore the default value, 0x7E (flags).
See idle-character.
Use to configure a serial interface in the slot/port format.
slot—Number of the slot in which the line module resides in the chassis
port—Number of the port on the I/O module
Example
host1(config)#interface serial 3/0
Use the no version to disable the interface.
See interface serial.
Use to enable data stream inversion for the interface.
Enable data stream inversion only if it is turned on at the other end of the line.
Example
host1(config-if)#invert data
Use the no version to disable the feature.
See invert data.
Use to set the time interval at which the router calculates bit and packet rate counters.
Choose a multiple of 30 seconds, in the range 30–300 seconds.
Example
host1(config-if)#load-interval 90
Use the no version to restore the default value, 300 seconds.
See load-interval.
Copyright © 2010, Juniper Networks, Inc.