Table of Contents
Advertisement
JunosE 11.2.x Physical Layer Configuration Guide
Displaying Counters and Time Intervals
Output Filtering
baseline interface
show controllers e3
show controllers t3
64
Counters and time intervals are MIB statistics, which are defined in
RFC 2496—Definitions of Managed Objects for the DS3/E3 Interface Types (January
1999).
The show controllers t3 slot/port all command displays the following interface
information:
Status information
T3 current interval counters—Displays the counters for the current interval
T3 last interval counters—Displays the counters for the previous interval
T3 24-hour total counters—Displays the cumulative counters for the last 24-hours or
since the interface was started
The last 24-hours of 15-minute reporting intervals (96 intervals)
The show controllers e3 slot/port all command displays identical information for an
E3 controller (except where noted).
You can use the output filtering feature of the show command to include or exclude lines
of output based on a text string you specify. See Command Line Interface in JunosE System
Basics Configuration Guide.
Use to set a statistics baseline for serial interfaces.
The router implements the baseline by reading and storing the statistics at the time
the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
Use the optional delta keyword with the show interfaces serial commands to view
the baseline statistics.
Example
host1#baseline interface serial 2/0
There is no no version.
See baseline interface.
Use to display the parameters and MIB statistics on an interface.
Use the brief keyword to display the administrative and operational status of all
configured T3 or E3 interfaces, or to display abbreviated information for the specified
T3 or E3 interface.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
