Juniper JUNOSE 11.2.X PHYSICAL LAYER Configuration Manual page 108

JunosE 11.2.x Physical Layer Configuration Guide
shutdown
snmp trap link-status
trigger delay
86
Use to specify that the interface supports SDH.
Example
host1(config-controller)#sdh
Use the no version to revert to SONET operation on this interface.
See sdh.
Use to disable a SONET/SDH interface.
SONET/SDH interfaces are enabled by default.
Example
host1 (config-controll)#shutdown
Use the no version to restart a disabled interface.
See shutdown.
Use to enable SNMP link-status processing for the section and line layers of the
interface.
The default is enabled.
Example
host1(config-controll)#no snmp trap link-status
Use the no version to disable SNMP link status processing.
See snmp trap link-status.
Use to set the time that the router waits to set an alarm when the router records a
defect at the line or section layer.
Change this value from the default only when you are using MPLS fast reroute over a
SONET/SDH interface.
Specify a value of 0 milliseconds if the interface does not use APS/MSP or if you
want MPLS to have priority over APS/MSP.
Specify a value of at least 100 milliseconds if this interface uses APS/MSP and if
you want APS/MSP to have priority over MPLS.
Example
host1(config-controll)#trigger delay msec 1000
Use the no version to restore the default setting, 2500 milliseconds.
See trigger delay.
Copyright © 2010, Juniper Networks, Inc.