Table of Contents
Advertisement
JUNOS OS 10.4 Release Notes
132
Remove
multilink-max-classes
Remove
link-layer-overhead
If the LFI forwarding class is mapped to
the configuration hierarchy is enabled on
Add
interleave-fragments
Adjust classifier configured for LFI on
packets to Q2
If the aforementioned instructions are not followed, the bundle will be incorrectly
processed.
On SRX Series devices, as per the new behavior, on configuring identical IPs on a single
interface users no longer see a warning message; instead, a syslog message appears.
On SRX210 Low Memory devices, ICMP messages generated in flow mode are now
rate-limited to 20 messages every 10 seconds. This rate limit is calculated on a per-CPU
basis.
Installation
On SRX100, SRX210, SRX220, SRX240, and SRX650 devices, support for USB
auto-installation is added. This feature simplifies the upgrading of Junos OS images
in cases where there is no console access to an SRX Series device located at a remote
site. This feature allows you to upgrade the Junos OS image with minimum configuration
effort by simply inserting a USB flash drive into the USB port of the SRX Series device
and performing a few simple steps. This feature can also be used for reformatting boot
devices and recovering SRX Series devices after a boot media corruption.
Integrated Convergence Services
On SRX210 device with Integrated Convergence Services, users cannot clone the
existing configuration for Integrated Convergence Services. The clone option has been
removed from all Convergence Services pages on J-Web.
Interfaces and Routing
On SRX100, SRX210, SRX220, SRX240, and SRX650 devices, support for USB
auto-installation is added.
On SRX Series devices, to minimize the size of system logs, the default logging level
in the factory configuration has been changed from
On SRX3000 and SRX5000 line devices, the
routing-options flow
CLI statements are no longer available, because BGP flow spec
functionality is not supported on these devices.
On SRX100, SRX210, SRX240, and SRX650 devices, the autoinstallation functionality
on an interface enables a DHCP client on the interface and remains in the DHCP client
mode. In previous releases, after a certain period, the interface changed from being a
DHCP client to a DHCP server.
from
, if configured.
[ls-0/0/0 unit 0]
from
, if configured.
[ls-0/0/0 unit 0]
no-fragmentation
in Junos OS Release 10.4, then
lsq-0/0/0
under
[ls-0/0/0 unit 0]
under
lsq-0/0/0
any any
set protocols bgp family inet flow
Copyright © 2011, Juniper Networks, Inc.
in
and
fragmentation-map
to classify
[class-of-service]
to
.
any critical
and
set
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOS OS 10.4 - RELEASE NOTES REV 6 and is the answer not in the manual?