Table of Contents
Advertisement
Copyright © 2011, Juniper Networks, Inc.
Issues in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers
On an NSR LDP, an LDP database entry mismatch exists between the master and the
backup Routing Engines. The backup Routing Engine does not replicate the LDP socket
with the error "jsr_sdrl_set_data: No space dlen." [PR/552945: This issue has been
resolved.]
When a default route target is sent by a BGP peer, th eBGP does not track the VPN
routes covered by this route target. When the default route target goes away, the BGP
does not withdraw the VPN routes that were previously covered by that default route
target. [PR/556432: This issue has been resolved.]
On a 3D MPC, the load balance might be broken when a BGP multipath is configured.
[PR/557099: This issue has been resolved.]
On M Series, MX Series, and T Series routers, the Virtual Router Redundancy Protocol
(VRRP) process might become unresponsive when processing is delegated to the
Packet Forwarding Engine. As a workaround, remove the
from the
[protocols vrrp]
hierarchy level. [PR/559033: This issue has been resolved.]
When the
advertise-default
is added, the necessary route refresh is not sent. [PR/561211: This issue has been
resolved.]
When the Link Layer Discovery Protocol (LLDP) advertisement interval value is changed
from 30 seconds to 60 seconds, and the
output shows 60 seconds. However, the Routing Engine forwards the LLDP packet
every 30 seconds. When the interface is deactivated and activated again, the LLDP
packets are forwarded every 60 seconds correctly. [PR/560857: This issue has been
resolved.]
Under certain circumstances, the routing protocol process crashes while receiving the
IGMP SNMP GetNext request. [PR/561842: This issue has been resolved.]
The multicast snooping process might crash and prevent a commit when the
statement is used at the
apply-group
This issue has been resolved.]
The routing protocol process might crash in the following environments:
Auto-export is configured for route leaking between VRFs.
Communities are added in the import policy of the second VPN routing and forwarding
(VRF) table.
[PR/563231: This issue has been resolved.]
Packets might not be correctly evaluated by a filter in an MPC that contains
noncontiguous prefixes. As a workaround, replace the noncontiguous prefixes with
equivalent sets of contiguous prefixes. [PR/564286: This issue has been resolved.]
On M10i and M7i routers, the distributed PPMD process is disabled by default. However,
it should be enabled by default since it is supported by the Enhanced CFEB (CFEB-E).
[PR/565957: This issue has been resolved.]
IS-IS might not use the MPLS label-switched paths (LSPs) if the names of the
label-switched paths are similar in the first 32 characters. [PR/568093: This issue has
been resolved.]
option is used with the route-target family, and a new VPN
show lldp detail
bridge-domain <*>
option
delegate-processing
command is executed, the
hierarchy level. [PR/562776:
65
Advertisement
Table of Contents
