Table of Contents
Advertisement
JUNOS OS 10.4 Release Notes
44
and maintenance domains. You can also use the
clear only one-way delay statistics or two-way delay statistics, respectively.
[Interfaces Command Reference]
Circuit Emulation (CE) interfaces firmware compatibility for ATM IMA on M7i, M10i,
M40e, M120, and M320 routers—Provides a
a
command output message in the IMA Group state and IMA Link state
show interface
if the PIC's firmware is not compatible in Junos OS Release 10.0 and later releases.
NOTE: CE PICs require firmware version
for ATM IMA functionality on M7i, M10i, M40e, M120, and M320 routers with
Junos OS Release 10.0R1 or later.
CE PICs manufactured with the 560-028081.pbin firmware will produce the following
entry in /var/log/messages when Junos OS is upgraded to Release 10.0R1 or newer
releases:
Firmware mismatch. Need to upgrade PIC PROM Binary CPU firmware for IMA.
If you configure IMA with this combination of Junos OS and CE PIC firmware, the
following entry will be seen.
Firmware error. Need to upgrade PIC PROM Binary CPU firmware for IMA.
The
show interfaces ce-fpc/pic/port
Physical link is Down
IMA Group state
: NE: Firmware Error
IMA Link state
: Line: Firmware Error
The customer must contact JTAC for a PIC firmware upgrade to proceed with IMA.
[Interfaces Command Reference, System Log Messages Reference]
Support for configuring shaping overhead—Support for CLI based configuration of
shaping overhead has been added to the PD-5-10XGE-SFPP Type 4 PIC.
Set bandwidth value on aggregated Ethernet interfaces—You can now set the
bandwidth value by using the
aggregate-interface unit number]
Additionally, the
show interfaces aggregate-inteface extensive
aggregate.logical-interface
it is configured. Also, the SNMP OID ifSpeed/ifHighSpeed of the aggregate logical
interface shows the corresponding bandwidth, when it is configured. When it is not
configured, the command shows it as the sum of the bandwidths of the member links
of the aggregate, as before.
Network interfaces
show
/
interfaces detail
extensive
truncated) names of the forwarding classes associated with queues.
[Network Interfaces]
one-way
Firmware mismatch
rom-ce-9.3.pbin
command output will show the following:
bandwidth value
statement at the
hierarchy level.
commands now show the bandwidth of the aggregate when
command output (All platforms)—The output of the
command now adds a table that shows complete (not
and
options to
two-way
syslog message and
or
rom-ce-10.0.pbin
[edit interfaces
and the
show interfaces
Copyright © 2011, Juniper Networks, Inc.
show
Advertisement
Table of Contents
