Errata And Changes In Documentation For Junos Os Release 10.4 For Srx Series Services Gateways And J Series Services Routers; Changes To The Junos Os Documentation Set - Juniper JUNOS OS 10.4 - RELEASE NOTES REV 6 Release Note

JUNOS OS 10.4 Release Notes
Related
Documentation
Errata and Changes in Documentation for Junos OS Release 10.4 for SRX Series Services
Gateways and J Series Services Routers
178
On SRX and J Series devices, the user was unable to configure the IPS-Exempt rule
only with attacks. J-Web forced the user to select the address and zones. [PR/ 522197:
This issue has been resolved.]
On SRX100, SRX210, and SRX240 devices, in J-Web, the resource utilization did not
load any data in the dashboard page using Firefox 3.0. [PR/564165: This issue has
been resolved.]
Unified Threat Management (UTM)
On SRX100 High Memory devices, when you used antispam and antivirus in the same
UTM-policy, spam were not tagged correctly. [PR/575296: This issue has been
resolved.]
Virtual LANs (VLANs)
On SRX100, SRX210, SRX220, SRX240, SRX650, and all J Series devices, the IRB
(VLAN) interface could not be used as the underlying interface for Point-to-Point
Protocol over Ethernet (PPPoE). [PR/528624: This issue has been resolved.]
VPNs
SRX5800 devices in Layer 2 transparent mode, did not allow the IPsec pass-through
VPNs to build. [PR/566160: This issue has been resolved.]
New Features in Junos OS Release 10.4 for SRX Series Services Gateways and J Series
Services Routers on page 92
Known Limitations in Junos OS Release 10.4 for SRX Series Services Gateways and J
Series Services Routers on page 148
Errata and Changes in Documentation for Junos OS Release 10.4 for SRX Series Services
Gateways and J Series Services Routers on page 178

Changes to the Junos OS Documentation Set

This section lists changes in the documentation.
Single Commit on J-Web
The following information pertains to SRX Series devices:
For all J-Web procedures, follow these instructions to commit a configuration:
If Commit Preference is Validate and commit configuration changes , click OK.
Copyright © 2011, Juniper Networks, Inc.