Table of Contents
Advertisement
CHAPTER 1
Intrusion Detection and Prevention Device
and NSM Installation Overview
Intrusion Detection and Prevention Device Installation Overview
Related Topics
NSM Installation Overview
Copyright © 2010, Juniper Networks, Inc.
Intrusion Detection and Prevention Device Installation Overview on page 3
NSM Installation Overview on page 3
The Intrusion Detection and Prevention (IDP) series consists of hardware and software
components. You can install the IDP device and start configuring your system using the
following steps:
Decide on the physical location of the device.
1.
Install the device into your equipment rack.
2.
Connect power cables and power on.
3.
Perform some initial configuration steps.
4.
Install the device license key.
5.
See the installation documentation for your IDP model to install, configure, update, and
service a Juniper Networks IDP device.
NSM Installation Overview on page 3
NSM and Intrusion Detection and Prevention Device Management Overview on page 5
NSM is a software application that enables you to integrate and centralize management
of your Juniper Networks environment. You need to install two main software components
to run NSM: the NSM management system and the NSM user interface (UI).
See the Network Security Manager Installation Guide for the steps to install the NSM
management system on a single server or on separate servers. It also includes information
on how to install and run the NSM user interface. The Network Security Manager Installation
Guide is intended for IT administrators responsible for installing or upgrading to the NSM.
3
Advertisement
Table of Contents
Troubleshooting
