Juniper JUNOS OS 10.4 - RELEASE NOTES REV 6 Release Note page 185

Errata and Changes in Documentation for Junos OS Release 10.4 for SRX Series Services Gateways and J Series Services Routers
Copyright © 2011, Juniper Networks, Inc.
Note that when entering a URL with the
characters for any special characters in the URL. Use the following escape characters
for these common special characters:
Replace : with %3A
Replace with
/ %2F
Replace - with %2D
Replace with
. %2E
In the section "Example: Configuring a Redirect URL for Captive Portal (CLI)" in the
Junos OS Security Configuration Guide, the procedure description states that, after
authentication, users will be forwarded to the specified URL. Step 2 of the configuration
procedure, however, is incorrect. This command would forward users to
my-website.com before authentication, not after.
To redirect users after authentication, the command must include:
The IP address of the Infranet Controller to be used for authentication
The ?target= option and URL to distinguish a forwarding address to be used after
authentication
Escape characters substituted for any special characters in the URL name
The following text in Step 2 is incorrect:
[edit services unified-access-control]
user@host# set captive-portal my-captive-portal-policy redirect-url
https://my-website.com
The correct text for Step 2 is as follows:
[edit services unified-access-control]
user@host# set captive-portal my-captive-portal-policy redirect-url
https://192.168.0.100/?target=my%2Dwebsite%2Ecom
The "Disabling Switching on SRX100, SRX210, SRX220, and SRX240 Devices Before
Enabling Chassis Clustering" section of the Junos OS Security Configuration Guide
incorrectly states the command to set the root user password. The following set of
commands must be used to set the password:
Enter configuration mode.
1.
Enter the following commands:
2.
user@host# set system root-authentication plain-text-password
This setting is required if a root user password was not set.
user@host# delete vlans
user@host# delete interfaces
user@host# delete security zones security-zone trust interfaces
user@host# delete security zones security-zone untrust interfaces
option, you must substitute escape
?target=
185