Juniper JUNOS OS 10.4 - RELEASE NOTES REV 6 Release Note page 36

JUNOS OS 10.4 Release Notes
36
[Subscriber Access]
Support for VPLS Layer 2 wholesale configuration in a subscriber access
network—Enables you to configure Layer 2 wholesaling within a subscriber access
network. Wholesale access is the process by which an access network provider
(wholesaler) partitions the access network into separately manageable and
accountable subscriber segments for resale to other network providers. An access
network provider may elect to wholesale all or part of its network to one or more service
providers (retailers).
NOTE: In this release, Layer 2 wholesaling supports the use of only the
default logical system using multiple routing instances.
The Juniper Networks Layer 2 wholesale solution is similar to the Layer 3 wholesale
solution in many ways. However, when configuring the Juniper Networks Layer 2
wholesale solution, keep the following in mind:
No Layer 3 components (address assignment, Layer 3 interfaces, and so on) are
involved.
S-VLANs must be unique to any Gigabit Ethernet or Aggregated Ethernet interfaces
within the entire network (not just unique to one router).
Layer 2 wholesale supports only CoA disconnect and variable modification; CoA
service activation is not supported.
NOTE: For general information about configuring dynamic wholesale for
your subscriber access network, see the Broadband Subscriber Management
Solutions Guide.
To configure Layer 2 wholesale for a subscriber access network:
Configure a VLAN dynamic profile. See the Subscriber Access Configuration Guide
for details.
Include the
routing-instances
dynamic variable at the
$junos-interface-name]
Include the statement along with the
interfaces
variable at the [edit dynamic-profiles profile-name interface "$junos-interface-name"
routing-instances "$junos-routing-instance"]
Include the interfaces statement along with the
variable at the
[edit dynamic-profiles profile-name]
Include the unit statement along with the
the
[edit dynamic-profiles profile-name interface "$junos-interface-ifd-name"]
hierarchy level.
statement along with the
[edit dynamic-profiles profile-name interface
hierarchy level.
$junos-interface-name
hierarchy level.
$junos-interface-ifd-name
$junos-interface-unit
$junos-routing-instance
dynamic
dynamic
hierarchy level.
dynamic variable at
Copyright © 2011, Juniper Networks, Inc.